HYDRO KIT LOW TEMPERATURE By Samsung Climate Solutions
Bomba de calor
• Production of hot water
• Production of chilled water
• Max temp. 50
• terminal block for connecting probes/pump (not included)
• terminal block for solar pump connection (not included)
• Water battery connection for AHU
• Connection to radiant panels or low-temp radiators.
• Production of domestic hot water
The flow variation is determined by the difference between the room temperature and the set temperature (ΔT), and the temperature difference of the refrigerant between the inlet and outlet of the evaporator.
Obviously this continuous dialogue affects the performances and consequently the consumption of the outdoor unit.
For almost all indoor units, except for wall and ceiling models, the electronic expansion valve is installed inside. If the units are used without the valve, a distributor kit with two or three outputs is provided, or the possibility of installing the single valve on the outside.
The DVM S allows pump-down or pump-out of the refrigerant gas in indoor/outdoor units to facilitate the operation of maintenance or addition of new indoor units.
Summer/winter switching is performed by the user without any intervention by specialised operators.
The system also allows to customize the management of individual units allowing to have individual or group control of indoor units, through individual commands, group, centralized or via PC with special management software.
The DVM S system has a self-diagnosis and self-start program that verifies the correctness of all operating parameters.
Through wireless, all operating data is stored directly on the Smartphone or Tablet.